Your Phone + MTA Callbox = ALL Necessary Equipment

If you've got a standard touch-tone phone, the MTA Callbox is all the equipment you need for this calling - it's got a built-in router! And, unlike VoIP 'softphones,' headphones aren't required and there's no need for cumbersome keyboard dialing on your computer. Also, why not plug in that fax machine and send faxes digitally!

Our MTA Callbox is the key that unlocks the potential of your standard touchtone phone by combining it with your high-speed internet connection so you can use the new way of making phone calls. It converts your phone's analog signal into a digital signal that is sent over the Internet. No extra equipment is necessary, and the MTA doesn't interrupt your computer's internet connection so you can surf the web while you make calls!

'Plug-and-Play' Setup
The MTA Callbox arrives fully configured and ready to use. All you need to do is plug your telephone and Internet connection into the back of the Callbox, plug in the electrical power, and you're ready to go!

	Connect the WAN port of the Multimedia Adapter to either your DSL modem or your cable modem with an Ethernet cable.
	Connect the PC port of the Multimedia Adapter to the Ethernet port of your PC or router with an Ethernet cable.
	Connect a telephone to the TEL 1 connector using a standard phone line.
	Plug in the power cord into the POWER connector on the MTA. Depress the ON/OFF button to power on the device.
	The POWER light on the front of the device will illuminate. Wait a few minutes to allow your device to initialize.

MTA-102 Troubleshooting:
There is no dial tone:
1. Check to make sure your phone is plugged into the MTA's "TEL1 Port" and "TEL2 Port" if the 2 port is available.

2. Check to make sure that the "TEL1" (and TEL2) light is on. If the TEL1 (and TEL2) light is not on check all the connections and then reboot the xDSL or Cable Modem.

Download MTA 102 User Guide (approx. 2.47 MB)